I always want to learn drawing or at least sketching before start to sculpting, so this was my first attempt at drawing my project before I start to sculpt. This was RAF pilot in world war 2 era and I make a chibi scale so it will suit for those who make eggplane or toon scale model kit 

 

 

  

This was a 3d printed base from Illustration that I drew above. Next article I’ll do molding him in silicon rubber and start to mass produce in resin and painting him.

 Hi all..it's been two years I don't post anything in my blog, as you can see my latest update is in 2018. sorry for not being update, but for now I'll try my best to update and active again at least once a week to give you any information or update that I working on my hobby lately.

 so in past two years and now almost we go to year 2022 so many happen change in my work even itn hobby or  my profesional job.Beside  of pandemi in 2019 and still going on right now, I no longer do traditional sculpting and tranform to digital sculpt. and I start to buy some 3d printer both DLP resin and FDM. 

 Print one of my sculpt in 1/35 scale as a test print with Anycubic photon DLP resin. the result are amazing and yeah there's still a little tiny print line or island mark in it, but that's ok a little bit of fine sanding should clean it.

for FDM printer I'll use it for bigger model like 1/6 scale figure or maybe I need to do some diorama like building or something that not fit on my anycubic printer since the bed or print size is smaller than My FDM printer.